Tratamiento de agua para la generación de energía: En enero de 2016 Quantum Filtration Medium realizó una serie de visitas al sitio para evaluar las opciones para mejorar la planta de tratamiento de agua que suministra agua a la central eléctrica de Kuala Langat (KLPP). El objetivo era destacar las opciones de bajo costo con un bajo impacto en la capacidad de servicio de la planta para aumentar el rendimiento de la planta, la eficiencia y la confiabilidad, y la capacidad de hacer frente mejor a los cambios de carga estacionales experimentados en el suministro de agua cruda.
La operación de KLPP ha comenzado desde 1996 utilizando turbina de gas de ciclo combinado y la planta está contribuyendo actualmente con 675MW de capacidad de generación de electricidad a la red. La capacidad de la planta para suministrar electricidad a la red de acuerdo con su obligación en virtud del Acuerdo de Compra de Energía depende de una serie de factores, incluido el suministro fiable de agua limpia con el fin de enfriar. En promedio, KLPP extrae 20.000 metros cúbicos de agua tratada para su funcionamiento diario. Para un funcionamiento óptimo y la vida útil de la planta, el agua debe estar lo más limpia posible con bajo contenido de sustancia orgánica o inorgánica que afectaría el funcionamiento de la planta.
Hay cuatro áreas principales de la planta donde se identificó el potencial de mejoras considerables.
• La posibilidad de añadir agua de perforación al suministro de agua cruda
• Aclaración del agua cruda antes de entrar en la planta
• Optimización del programa de dosificación de floculantes/polímeros (tipo inc. y tasa de dosificación)
• Cambio de los medios en los filtros de arena rápidos a DMI65®
BORE WATER ADDITION
It was suggested that the area surrounding the plant be assessed for suitability and potential quality and quantity of several bores to add to the plant raw water supply. The addition of bores would not only provide greater flexibility in terms of seasonal blending with river water to ensure sufficient quantities of water in the dry season, could also be used to lower suspended solids and turbidity loadings on the plant during the wet season.
There is a likelihood that there will be traces of iron and manganese in the bore water, but the use of DMI65 filtration media will remove this and provide an improvement to the usual mechanical filtration duties.
CLARIFICATION
The high turbidity and suspended solids levels in the raw water could be greatly reduced by clarification prior to entering the water treatment plant. The existing plant is fixed in size and capacity, however a pre-clarification stage will dramatically reduce the load on the current plant.
A traditional clarifier and upstream floc/polymer dosing system to handle 1ML/hr would cost well over USD $1M and take up a considerable land area to install and was therefore not practical in this case. With a very low retention time this type of system would also require very high chemical usage.
POLYMER OPTIMISATION
A range of polymer samples were supplied during the site visit. Jar testing has been carried out using the range of samples and highlighted a particular polymer most suited to this raw water. A local polymer supply company is able to supply a very similar product in powdered form and at a very reasonable price that would suit the mixing/batching system mentioned above.
MEDIA CHANGE-OUT IN RAPID SAND FILTERS
During our visit one of the rapid sand filters was drained for inspection. The sand in the filters has never been changed and is now very hard-packed and is in need of replacement. The filter was filled whilst we were watching and the infiltration rate of the incoming water was very poor with most of the water just flowing across over the top of the sand and down through cracks in the hard packed sand rather than down through it. We proposed to replace the media with DMI65® filtration media.
The DMI65 will remove the existing and cope with any rise in iron or manganese levels that can be encountered in raw water sources with varying quality. The DMI65 requires a low level of free chlorine (0.2-0.3mg/L) to activate the media. This is easily achieved as it only requires moving of the existing chlorine dosing point to just prior to the media filters. The chlorine residual will remain and still act as disinfection for the treated water lagoon.
The DMI65® also provides the perfect filtration coefficient resulting in excellent mechanical filtration lowering suspended solids and turbidity levels.
The addition of the DMI media and replacement of the filtration nozzles improved not only the quality of water from the media filters, but also the quantity of water through the filters.
Sample Results
With a peak NTU of 1000 and an average inlet TSS of 286 you can see that the outlet of lagoon B has been maintained generally around 80 NTU with an average of 86 NTU.
OVERALL PLANT OUTPUT
The results from the plant post media filters after the replacement of the old sand media with the new DMI65 media have been consistently excellent.
The expected results from the media filters after the upgrade were:
TSS < 5mg/L
Turbidity < 2 NTU
Sample Results
Media Filter Performance – NTU In Vs Out
Summary
Quantum believes that the upgrade has been a success, addressing the main objectives of the upgrade with excellent results.
George Municipal Water Works, Sudáfrica, utiliza más de 550 toneladas métricas de DMI-65®. El agua de George es altamente coloreada que contiene ácidos húmicos y fúlvicos – el color de agua cruda es aprox. 800 unidades de color PtCo. Se cree que este tipo de agua es una de las más difíciles de filtrar. La eliminación de hierro es muy eficaz independientemente del pH. El hierro residual más alto encontrado fue de 0,01 mg/L. La eliminación de manganeso también es muy eficiente. El manganeso restante más alto encontrado fue 0,06 mg/l Mn se elimina mejor a pH 8 más alto. El beneficio adicional de la extracción de aluminio incluso en el pH más alto. La turbidez más alta registrada fue 0,06 NTU. Según nuestras pruebas de laboratorio, el color más alto fue de 4 mg/l PtCo, pero la mayoría de las veces el color era inferior al color del agua destilada comprada en una farmacia de George. La planta funciona desde principios de enero de 2007 y sigue teniendo excelentes resultados. George Municipal Water Works, utiliza el mismo DMI-65® medios filtrantes durante más de 13 años, sin fallas ni disminuciones en el rendimiento.
La Planta Municipal de Tratamiento de Aguas de Witbank en Durban, Sudáfrica, consta de 18 grandes filtros de arena rápida que utilizan 1200 toneladas de medios filtrantes para eliminar el hierro y el manganeso de la fuente local de agua subterránea. Los especialistas locales en tratamiento de agua y DMI-65® agente, Water Technologies Cape, demostraron el rendimiento y los beneficios de costos de la actualización del sistema a DMI-65®, mediante un exitoso ensayo piloto en 2018. Las mejoras a la planta comenzaron en 2019 y se espera que estén terminadas a finales de 2020.
Casos prácticos para el tratamiento de aguas en la industria de la generación de energía
Actualización de una planta de tratamiento de agua para garantizar una calidad óptima del agua
Quantum Filtration Medium (Quantum) realizó una serie de visitas al sitio para evaluar las opciones para mejorar la planta de tratamiento de agua (WTP) que abastecía a la central eléctrica de Kuala Langat (KLPP) en Malasia. El objetivo era destacar las opciones de bajo costo con un bajo impacto en la capacidad de servicio de…